Sellstrom Peakworks Press Block

Peakworks presents a patented tool tethering system that safeguards workers from tools dropped at height. These durable, long - lasting, and temperature - resistant tool anchor clamps are specifically crafted to prevent tools from falling through the commonly used 19 - 4 construction site grating, a safety feature no other system offers. Rigorously tested at the CSA test lab for maximum safety, these high - strength clamp fasteners can be easily installed and removed with the provided hex key wrench. Available in two sizes (1⁄2” – 3⁄4” and 11/16” – 1 1/4”), they come with a standard hex - shaped opening and a separate rubber insert. This insert can be placed between the tool and the clamp for better sizing compatibility and a stronger grip. The system is designed for round and hex shank tool bodies and larger tools, operating within a temperature range of - 40ºF to 104ºF (- 40ºC to 40ºC). Developed and manufactured in Canada, the Peakworks system offers the strongest and most secure tool anchor clamping mechanism on the market. The high - strength HDPE clamps can be securely attached to various flat, hex, and round tool bodies. The HDPE materials are suitable for extreme cold and high - heat applications. Unlike traditional heat - tape anchoring systems, these clamps can be reused and repositioned, saving costs. All Peakworks anchor clamps have a strong, molded eye hole for easy attachment to wrist or standard lanyards with built - in carabiners. They are available in individual blister packs or 10 - piece bulk packs (5 bulk packs - 50 pieces per box).

Using the Peakworks Press Block is easy. First, select the right size clamp for your tool. There are two sizes available: 1⁄2” – 3⁄4” and 11/16” – 1 1/4”. If needed, place the rubber insert between the tool and the clamp to ensure a good fit and strong grip. Then, use the provided hex key wrench to securely install the clamp onto your tool. The clamps can be attached to round, hex, or flat - shaped tool bodies. When you're done using the tool, you can easily remove the clamp with the hex key wrench and reuse it later. The Peakworks Press Block is designed to work in temperatures from - 40ºF to 104ºF (- 40ºC to 40ºC). Avoid using it outside of this temperature range. Make sure to check the clamp regularly for any signs of wear or damage. If you notice any issues, replace the clamp immediately. Store the clamps in a dry place when not in use to keep them in good condition. This will help ensure the long - lasting performance of your Peakworks Press Block.